跳转到主内容

Reemplazo del panel frontal iPad 4G

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的153指南

英语
西班牙语

正翻译步骤 18

步骤 18
Removing iPad 3 4G Front Panel: 步骤 0 中的图像 1,3 Removing iPad 3 4G Front Panel: 步骤 0 中的图像 2,3 Removing iPad 3 4G Front Panel: 步骤 0 中的图像 3,3
  • Slide the opening pick along the top edge of the iPad, pulling it out slightly to go around the front-facing camera bracket.

  • The adhesive along this section is very thick, and a fair amount of force may be required. Work carefully and slowly, making sure to not slip and damage yourself or your iPad.

  • If the adhesive has cooled too much, replace the iOpener along the top edge and continue working. If the iOpener has cooled too much, reheat it.

  • If the opening pick is getting stuck in the adhesive, "roll" the pick as shown in step 9.

Desliza la púa de apertura a lo largo del borde superior del iPad, tirando ligeramente hacia fuera para rodear el soporte frontal de la cámara.

El adhesivo a lo largo de esta sección es muy grueso, y puede requerirse una cantidad justa de fuerza. Trabaja con cuidado y lentamente, asegurándose de no resbalar y dañarse a sí mismo o a tu iPad.

Si el adhesivo se ha enfriado demasiado, reemplace el iOpener a lo largo del borde superior y continúa trabajando. Si el iOpener se ha enfriado demasiado, vuelva a calentarlo.

Si la picadura de apertura está pegada en el adhesivo, "ruede" la selección como se muestra en el paso 9.

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利