跳转到主内容

Reemplazo del panel frontal iPad 4G

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的153指南

英语
西班牙语

正翻译步骤 15

步骤 15
Removing iPad 3 4G Front Panel: 步骤 0 中的图像 1,3 Removing iPad 3 4G Front Panel: 步骤 0 中的图像 2,3 Removing iPad 3 4G Front Panel: 步骤 0 中的图像 3,3
  • Continue releasing the adhesive along the bottom of the iPad, pulling the opening pick out far enough to go around the home button, and re-inserting it to a depth of 1/2 inch (10 mm) once the pick is past the home button.

  • If the adhesive has cooled too much along the bottom edge, reheat the iOpener to warm the adhesive where you are working.

  • Do not heat the iOpener more than a minute at a time, and always allow at least two minutes before reheating it.

Continúa soltando el adhesivo a lo largo de la parte inferior del iPad, tirando de la selección de apertura lo suficiente para rodear el botón de inicio, y volver a insertarlo a una profundidad de 10 mm una vez que la púa esté pasado el botón de inicio.

Si el adhesivo se ha enfriado demasiado a lo largo del borde inferior, recalienta el iOpener para calentar el adhesivo donde está trabajando.

No calientes el iOpener más de un minuto a la vez, y siempre deja al menos dos minutos antes de recalentarlo.

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利