注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的9本指南。
正翻译步骤 10
步骤 10
-
Remove the following screws securing the logic board to the rear case:
-
Two 2.3 mm Phillips screws
-
Two 2.7 mm standoff screws
-
One non-magnetic 2.7 mm standoff screw
[* black] Remove the following screws securing the logic board to the rear case: |
[* red] Two 2.3 mm Phillips screws |
[* orange] Two 2.7 mm standoff screws |
[* icon_note] Standoff screws are best removed using |
[* icon_note] Standoff screws are best removed using |
[* icon_caution] In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components. |
[* yellow] One non-magnetic 2.7 mm standoff screw |
[* icon_note] Be sure to put this screw back in its original position at the top of the logic board. A magnetized screw may interfere with the digital compass. |