跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的22指南

英语
日语

正翻译步骤 15

步骤 15
Make sure the battery is disconnected before you disconnect or reconnect the cables in this step. Use a plastic opening tool or a fingernail to disconnect the three front panel assembly cables: Front-facing camera and sensor cable
Disconnecting the front panel assembly cables
  • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

  • Use a plastic opening tool or a fingernail to disconnect the three front panel assembly cables:

  • Front-facing camera and sensor cable

  • LCD cable

  • Digitizer cable

  • When reassembling your phone, the LCD cable may pop off the connector. This can cause white lines, or nothing at all to appear when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.

フラスチックの開口ツールを使って次の3つのフロントパネルアセンブリケーブルを外します。

正面カメラとセンサーケーブル

LCDケーブル

デジタイザーケーブル

デバイスを再組み立てする際、LCDケーブルがコネクターから外れることがあります。これは電話の電源を入れた時、画面にホワイトラインや何も表示されない原因となります。もしこの状態が発生したら、単純にケーブルを再接続し、電源を再起動させてください。電源を再起動する方法については、バッテリーの再接続をご覧ください。

[*title] Disconnecting the front panel assembly cables
[* icon_caution] Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
[*
black] Use a plastic opening tool or a fingernail to disconnect the three front panel assembly cables:
[*title] Disconnecting the front panel assembly cables
[* icon_caution] Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
[*
black] Use a plastic opening tool or a fingernail to disconnect the three front panel assembly cables:
[* red] Front-facing camera and sensor cable
[* orange] LCD cable
[* yellow] Digitizer cable
[* icon_caution] When reassembling your phone, the LCD cable may pop off the connector. This can cause white lines, or nothing at all to appear when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to [guide|10587|disconnect and reconnect the battery|stepid=38507battery|stepid=133257].
[* icon_caution] When reassembling your phone, the LCD cable may pop off the connector. This can cause white lines, or nothing at all to appear when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to [guide|10587|disconnect and reconnect the battery|stepid=38507battery|stepid=133257].

在开源创作共享许可协议下,你的投稿已被许可