跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的4指南

英语
中文

正翻译步骤 2

步骤 2
Once the back panel is warm to the touch, apply a suction cup as close to the heated edge of the phone as you can while avoiding the curved edge.
  • Once the back panel is warm to the touch, apply a suction cup as close to the heated edge of the phone as you can while avoiding the curved edge.

  • The suction cup will not adhere well on the curved portion of the glass.

  • If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

  • Lift on the suction cup and insert an opening pick under the rear glass.

  • Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone.

  • If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

用手摸背板已经热了之后,在版面上靠近已加热的边缘处安装一个吸盘,越靠近越好,但要避开曲边。

吸盘在曲边上吸不住。

如果玻璃背板已经碎了的话,吸盘可能吸不住。尝试用强力胶带来拉起背板或者用胶水把吸盘粘在背板上,这样你就可以继续了。

抬起吸盘并且在玻璃板缝隙处放入一个撬片。

由于玻璃曲面的关系,你将会向上推,而不是与手机平面平行推撬片。

如果在此步骤遇到了问题,再加热让胶软化,然后再次尝试。胶水冷却地非常快,因此你可能需要重复加热它。

在开源创作共享许可协议下,你的投稿已被许可