跳转到主内容

注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的5本指南

英语
中文

正翻译步骤 3

步骤 3
Secure a suction cup to the back cover, as close to the heated edge as possible. The suction cup will not make a good seal on the curved portion of the glass, so avoid putting it on the very edge.
  • Secure a suction cup to the back cover, as close to the heated edge as possible.

  • The suction cup will not make a good seal on the curved portion of the glass, so avoid putting it on the very edge.

  • If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

  • Lift the back cover's left edge with your suction cup, opening a slight gap between the back cover and the frame.

  • This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool.

  • If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

  • If you're using an iOpener, follow instructions to avoid overheating it, or the gel pack may burst.

将一个吸盘固定在背板上,尽可能靠近你加热过的那个边缘。

吸盘不是很喜欢弯曲的玻璃,所以不要靠边缘过近。

吸盘无法吸住破碎的玻璃,尝试使用强力胶带(图片链接),或者将吸盘用强力胶固定在背板上来保证以下步骤的顺利。

用吸盘抬起背板的左边,直到背板和中框之间有一条缝隙。

这可能需要大力出奇迹,但是你只要将缝开到你的工具能插入就够了。

如果还是有一些问题,试着再加热来软化胶条。因为胶条很快就会凉下来,所以通常需要大量反复加热。

如果你用的是iOpener,请遵循说明来避免她过热,否则有爆炸的可能性。

在开源创作共享许可协议下,你的投稿已被许可