跳转到主内容
英语
中文

正翻译步骤 4

步骤 4
Remove the three 8.4 mm #1 Phillips screws securing the heat sink to the logic board. Don't lose the springs held under each of the screws.
  • Remove the three 8.4 mm #1 Phillips screws securing the heat sink to the logic board.

  • Don't lose the springs held under each of the screws.

  • Carefully remove the heat sink from the processor.

  • If the heat sink seems to be stuck, it may be helpful to gently pry it off the processor with a plastic spudger. Be careful not to break any surface mount components on the processor while prying.

  • Be sure to clean off the old thermal paste and apply a new layer before you reinstall the heat sink. We have a guide that makes it easy.

拆下将散热器固定到主板上的三个8.4 mm#1十字螺丝。

不要丢失每个螺丝下的弹簧。

小心地从处理器中取出散热器。

如果散热片似乎被卡住,用塑料撬棒轻轻地将其从处理器上撬开也许是有用的。 小心不要在撬动时破坏处理器上的任何表面贴装元件。

在重新安装散热器之前,请确保清洁旧的热粘贴并应用新的层。 我们有一个简单易懂的指南。

在开源创作共享许可协议下,你的投稿已被许可