注:你正在为你刚才查阅的指南编辑前提条件。你所做的任何更改将影响包括此步骤的5本指南

英语
中文

正翻译步骤 5

步骤 5
Insert a spudger just to the left of the hinge opening on the top edge of the display between the front display bezel and the plastic strip attached to the rear bezel. Pry the rear bezel away from the front bezel along the top left half of the display. If the flat end of your spudger is flexing too much, trim about .125" of the end to increase its stiffness.
  • Insert a spudger just to the left of the hinge opening on the top edge of the display between the front display bezel and the plastic strip attached to the rear bezel.

  • Pry the rear bezel away from the front bezel along the top left half of the display.

  • If the flat end of your spudger is flexing too much, trim about .125" of the end to increase its stiffness.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可