跳转到主内容

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的指南

英语
中文

正翻译步骤 3

步骤 3
Using the plastic spudger tool, gently pry on either side of main power connector (CON801) to disconnect from main logic board. Pry a little bit on each side of board until the board lifts away. Tilt the board forward and lift up to remove from the chassis.
  • Using the plastic spudger tool, gently pry on either side of main power connector (CON801) to disconnect from main logic board.

  • Pry a little bit on each side of board until the board lifts away.

  • Tilt the board forward and lift up to remove from the chassis.

在此插入翻译

在此插入翻译

在此插入翻译

在开源创作共享许可协议下,你的投稿已被许可