Skip to main content

介绍

This guide outlines how to replace the entire fan unit rather than fixing the entire unit itself, because doing so would require advanced techniques such as soldering. This replacement is needed when dirt clogs the fan due to the close proximity between the fan and the vacuum bin.

配件

没有特定配件。

  1. Press the black circular button on the back end of the Roomba and pull the bin out towards you to remove the vacuum bin.
    • Press the black circular button on the back end of the Roomba and pull the bin out towards you to remove the vacuum bin.

  2. Lay the vacuum bin down and remove the six 15 mm screws around the outside of the vacuum bin using the Phillips JIS #1 driver. Remove the top of the vacuum bin by pulling it straight up.
    • Lay the vacuum bin down and remove the six 15 mm screws around the outside of the vacuum bin using the Phillips JIS #1 driver.

    • Remove the top of the vacuum bin by pulling it straight up.

    • The bin is composed of two parts (the clear top casing and the red bottom filter). To avoid a mess, be careful to not let these two pieces detach, unless over a trash bin.

  3. Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物

    Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物
  4. Remove the three 10 mm screws that surround the fan using the Phillips JIS #1 driver. Remove the casing that surrounds the fan by pulling it straight up. The casing is composed of 2 parts (the large top casing, and a small air filter). If these parts detach, they are very easy to put back together. Do not lose the air filter.
    • Remove the three 10 mm screws that surround the fan using the Phillips JIS #1 driver.

    • Remove the casing that surrounds the fan by pulling it straight up.

    • The casing is composed of 2 parts (the large top casing, and a small air filter). If these parts detach, they are very easy to put back together. Do not lose the air filter.

  5. Turn over the remainder of the fan casing and remove the single 15mm screw, using the Phillips JIS #1 screwdriver. Remove the casing from the fan and battery component by pulling it straight up. Remove the casing from the fan and battery component by pulling it straight up.
    • Turn over the remainder of the fan casing and remove the single 15mm screw, using the Phillips JIS #1 screwdriver.

    • Remove the casing from the fan and battery component by pulling it straight up.

  6. Remove the small black button from the top of the battery.
    • Remove the small black button from the top of the battery.

    • Save the spring and the button cover. The remainder of the fan assembly (yellow motor and the black housing) will need to be replaced as a unit.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

TJ Tamura

于2015年10月01日注册

226 Reputation

撰写一个指南

Team

Cal Poly, Team 1-22, Maness Fall 2015 Cal Poly, Team 1-22, Maness Fall 2015 的会员

CPSU-MANESS-F15S1G22

4 名成员

创作了14篇指南

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 5

Past 30 Days: 32

All Time: 1,936