简介

This guide explains how to remove the brushes from your iRobot Roomba 551, either for replacement or cleaning.

  1. Place your Roomba upside-down on a hard surface.
    • Place your Roomba upside-down on a hard surface.

    If all you need off is the faceplate, skip all of the screwdriver-based steps, and just remove the dirt bin(step 7) and start from step 11 at the rear.

    David Forrest - 回复

  2. While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.
    • While holding the side brush in place, use a Phillips #1 screwdriver to remove the 4.5mm screw from the center of the brush.

    添加评论

    • Gently pull upwards on the brush to remove it.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Rotate the Roomba upside-down so the bottom is facing towards you.

    添加评论

    • Using a Phillips #2 screwdriver, remove the captive screws that hold the bottom plate in place.

    添加评论

    • Carefully lift the bottom plate.

    • The battery is only secured in place by the bottom plate, and may fall out once the bottom plate is removed.

    添加评论

    • Pinch the yellow tabs on the sides of the brush cage and lift up to open.

    添加评论

    • Grab each brush and lift upwards to remove.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

John McTigue

于2014年01月31日注册

331 信誉积分

创作了3篇指南

团队

Cal Poly, Team 13-14, Regan Winter 2014 Cal Poly, Team 13-14, Regan Winter 2014 的会员

CPSU-REGAN-W14S13G14

4 名成员

创作了13篇指南

Should be no need to remove the back plate. Just open the brush cage and lift out the brushes

Gunnar Nybraten - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 9

总计 969