简介
If the iRobot Looj 120 has stopped working and all the motors are okay and the battery is charged, then there may be a problem with the circuit board within the handle. This guide will show you how to replace the circuitry in the remote handle.
你所需要的
-
-
Remove the four exterior screws located under controller and on the handle.
-
Remove the five screws shown, and then carefully remove top plate. Electrical components are attached to top plate.
-
-
即将完成!
To reassemble your device, follow these instructions in reverse order.
结论
To reassemble your device, follow these instructions in reverse order.