简介

Battery not lasting long? Swap it out.

Before opening your iPod, ensure that the hold switch is in the locked position.
  • Before opening your iPod, ensure that the hold switch is in the locked position.

添加评论

Opening the iPod can be challenging; don't get discouraged if it takes you a few tries to get the iPod to open.
  • Opening the iPod can be challenging; don't get discouraged if it takes you a few tries to get the iPod to open.

  • Insert a plastic iPod opening tool in the seam between the white plastic front and metal back of the iPod. It helps to hold the iPod at top and bottom as shown and squeeze to help pop out the edge. Once you've inserted the tool, run it along the seam to free the five tabs holding the iPod together.

添加评论

Continue to run the opening tool along the side of the case until all five tabs have been released.
  • Continue to run the opening tool along the side of the case until all five tabs have been released.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.
  • Work around the corner of the iPod and release the two tabs holding the iPod together near the dock connector.

添加评论

Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.
  • Free the five tabs holding the iPod together on the other side. You may be able to free the tabs by gently wiggling the front panel of the iPod.

  • Lift the rear panel away from the iPod.

添加评论

Lift the battery up from the adhesive holding it to the iPod.
  • Lift the battery up from the adhesive holding it to the iPod.

  • Lay the battery next to the iPod (it is still connected to the logic board).

添加评论

Lift up the end of the hard drive near the Firewire port to allow easy access to the battery connector.
  • Lift up the end of the hard drive near the Firewire port to allow easy access to the battery connector.

添加评论

Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.
  • Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

19等其他人完成本指南。

iRobot

于2009年09月24日注册

1 信誉积分

创作了750篇指南

There are so many iPods, it's confusing as to what battery to buy. I have 3 of these old bricks and sure it's battery time. Can you please provide a link to the specific battery for this (above) iPod?

caseyhales - 回复

The iPod that I,m trying to resssurect has a connection that has 50t pin connection. I ordered the battery shown in the picture and now have to exchange it

drich92346 - 回复

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 30

过去的30天: 104

总计 25,924