跳转到主内容

iPhone 7 Plus Display Assembly Replacement

仅作为前提条件
本指南仅用作其他指南的先决条件。不能单独食用。

你所需要的

  1. iPhone 7 Plus Display Assembly Replacement, Display Assembly: 步骤 1 中的图像 1,3 iPhone 7 Plus Display Assembly Replacement, Display Assembly: 步骤 1 中的图像 2,3 iPhone 7 Plus Display Assembly Replacement, Display Assembly: 步骤 1 中的图像 3,3
    • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

    • Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.

    • To re-attach press connectors, press down on one end until it clicks into place, then repeat on the other end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

    • If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.

  2. iPhone 7 Plus Display Assembly Replacement: 步骤 2 中的图像 1,3 iPhone 7 Plus Display Assembly Replacement: 步骤 2 中的图像 2,3 iPhone 7 Plus Display Assembly Replacement: 步骤 2 中的图像 3,3
    • Remove the three tri-point Y000 screws securing the bracket over the front panel sensor assembly connector:

    • One 1.3 mm screw

    • Two 1.0 mm screws

    • Remove the bracket.

  3. iPhone 7 Plus Display Assembly Replacement: 步骤 3 中的图像 1,2 iPhone 7 Plus Display Assembly Replacement: 步骤 3 中的图像 2,2
    • Disconnect the front panel sensor assembly connector from its socket on the logic board.

    • This press connector should also be reconnected one end at a time to minimize the risk of bending.

  4. iPhone 7 Plus Display Assembly Replacement: 步骤 4 中的图像 1,1
结论

To reassemble your device, follow these instructions in reverse order.

10等其他人完成本指南。

Paige Reisman

于04/07/14注册

23,586 声望

创作了15篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 5,464