iPhone 7 Display Assembly Replacement

步骤 1 Display Assembly




• Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
• Use a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.
• To reconnect these cables, press down on one end until it clicks into place, then repeat on the opposite end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.
• If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.
翻译
18条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 2




• Remove the two 1.3 mm Phillips screws securing the bracket over the front panel sensor assembly connector.
• Remove the bracket.
翻译
23条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 3
• Disconnect the front panel sensor assembly connector from its socket on the logic board.
• This press connector should also be reconnected one end at a time to minimize the risk of bending.
翻译
7条评论
添加一条评论
添加评论
1024
取消 发帖评论
步骤 4
• Remove the display assembly.
• During reassembly, pause here if you wish to replace the adhesive around the edges of the display.
翻译
6条评论
添加一条评论
添加评论
1024
取消 发帖评论

作者

与4其他贡献者

Evan Noronha

于02/05/15注册

223,427 声望

创作了168篇指南

徽章: 49

• 
• 
• 

+ 46更多徽章

嵌入本指南

选择一个尺寸并复制下面的代码，将本指南作为一个小插件嵌入到你的网站/论坛中。

预览