跳转到主内容

修复你的物品

维修的权力

商店

简介

iPhone water damage is a very common repair case, and it can result in different issues. For case today, iPhone 6 can't turn on after water damage. We start the repair work from moldy components. As it is often suggested that we should always begin with simple, then complex. However, the problem remains unresolved. Run further measurement and the faulty position is finally confirmed. We can complete the iPhone 6 water damage repair work by replacing faulty components.

视频概述

  1. Check the logic board. We can see clearly that the water damage indicator is red. Get  the phone powered on. The phone turns on with Apple logo. Yet the screen goes black after 15 seconds and cannot access the system normally.
    • Check the logic board. We can see clearly that the water damage indicator is red.

    • Get the phone powered on. The phone turns on with Apple logo. Yet the screen goes black after 15 seconds and cannot access the system normally.

    • Boot current reading on the ammeter jumps to 510mA and then stays still.

  2. First thing we do is to clean the logic board with PCB Cleaner. Then get the board powered on. Current reading on the ammeter jumps to 220mA and then stays still.
    • First thing we do is to clean the logic board with PCB Cleaner.

    • Then get the board powered on. Current reading on the ammeter jumps to 220mA and then stays still.

  3. Essential 工具包

    我们最紧凑的套装中最有用的工具。

    现在开始购物

    Essential 工具包

    我们最紧凑的套装中最有用的工具。

    现在开始购物
  4. We need to detach mouldy ICs on the board and run thorough cleaning.
    • We need to detach mouldy ICs on the board and run thorough cleaning.

    • We can see clearly that U1501 and U1503 bear obvious mouldy signs. Remove the two ICs and then clean their bonding pads.

  5. Continue to detach the two mouldy components, U2402 and U0900 from the board. We can see clearly that area under U2402 has got seriously mildewed. This might be the cause.
    • Continue to detach the two mouldy components, U2402 and U0900 from the board. We can see clearly that area under U2402 has got seriously mildewed.

    • This might be the cause.

  6. Clean these bonding pads carefully. Solder new ICs to the board. Solder new ICs to the board.
    • Clean these bonding pads carefully.

    • Solder new ICs to the board.

  7. Now we can assemble the phone and test.
    • Now we can assemble the phone and test.

    • Press power button to power on. The phone turns on normally.

3等其他人完成本指南。

Phryne

于2019年11月17日注册

14,826 信誉积分

创作了80篇指南

添加评论

浏览统计数据:

过去的24小时: 5

过去的7天: 21

过去的30天: 124

总计 1,250