简介
使用本指南拆卸和更换iPhone 6 Plus破裂或者损坏的屏幕。本指南向你展示怎样拆装下：Home键、前置摄像头以及感应器组件、显示液晶保护板、Home键排线，把这些组件装到你更换的前面板上。若想更换屏幕总成请点击以下链接：
另一方面，注意将原来的Home键安装到新的屏幕上，来确保Touch ID能够正常工作（指纹识别）。
视频观看地址：
你所需要的
-
-
如果您的手机显示屏已经碎裂，请避免屏幕进一步的破碎，并且当您用胶带粘贴屏幕玻璃以维修手机时，请避免身体部位受伤。
-
使用透明胶带交替重叠粘贴，完整地覆盖住手机的屏幕。
-
如果屏幕玻璃的碎裂导致接下来的步骤中的吸盘难以吸在屏幕上，请尝试使用黏度较高的胶带（如粘水管用的胶带）折叠成一个把手，来提起屏幕。
-
-
-
将蓝色手柄拉向铰链以解锁反向钳的手臂。
-
将反向钳手臂滑过 iPhone 的左边缘或右边缘。
-
将吸盘放在靠近 iPhone 底部边缘的位置——一个在正面，一个在背面。
-
向下推吸盘以将吸力施加到所需区域。
-
-
若想重新组装您的设备，请倒序按照本指南操作。
若想重新组装您的设备，请倒序按照本指南操作。
222等其他人完成本指南。
11条评论
I know this is a old guide but i have a question. My iphone was screen broken and i change it with a original complete iphone screen, the home button works fine but the touch id dont work. I change the home button to the one that i have in the broken screen and still the touch id dont work. What can i do to fix the touch id?
Help! The home button cable attached to the metal front panel ripped a little as I was gently using my fingers to lift it off the screen. Now the home button doesn't work. Did I ruin the phone or is it possible to get a front panel?
I recently purchased this iFixit kit for my iPhone 6 Plus replacement of my screen that was cracked. I followed the instructions above, and my phone won't turn on. There is a part in to the right of the battery, just below the screen connections, that is really hot. After I noticed it wouldn't turn on, even after plugging it in, I took it back apart, and reseated the connections again. It still doesn't work. I will not purchase this kit again.
Bought this recently and I must say that I'm a little bit disappointed:
- the screen doesn't fit as before, you can feel a rough edge - I tried 4 times to put it correctly watching many video tutorials and I had the same result so I assume it's because it's not an original screen
- the colours are not the same anymore, looks like the saturation is on a lower setting - can't see the bright colours anymore
Overall I would rate this part 6 out of 10.
andrewbuta - 回复
