跳转到主内容

修复你的物品

维修的权力

商店

简介

Internal Prereq.

  1. Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket. Be sure you are prying up on the hinged retaining flap, not the socket itself. Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.
    • Use the flat end of a plastic opening tool to flip up the retaining flap on the headphone jack and front-facing camera ribbon cable ZIF socket.

    • Be sure you are prying up on the hinged retaining flap, not the socket itself.

    • Run a plastic opening tool underneath the headphone jack and front-facing camera cable to free it from the adhesive attaching the cable to the rear panel.

    • Pull the headphone jack and front-facing camera ribbon cable straight out of its socket on the logic board.

  2. Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.
    • Remove the two 2.9 mm Phillips screws securing the headphone jack to the rear panel.

  3. Use the edge of a plastic opening tool to peel the tape and the adhesive securing the headphone jack & front camera cables to the rear panel. Use the edge of a plastic opening tool to peel the tape and the adhesive securing the headphone jack & front camera cables to the rear panel.
    • Use the edge of a plastic opening tool to peel the tape and the adhesive securing the headphone jack & front camera cables to the rear panel.

  4. Pull the headphone jack away from the top edge of the iPad.
    • Pull the headphone jack away from the top edge of the iPad.

    • Don't try to remove the assembly just yet. The front camera is still stuck to the rear panel.

  5. Lift the headphone jack & front camera cables slightly to access the microphone connector.
    • Lift the headphone jack & front camera cables slightly to access the microphone connector.

    • Use the edge of a plastic opening tool to separate the microphone connector from its socket on the headphone jack & front camera cables.

  6. Peel the front camera off the foam adhesive securing it to the rear panel. Remove the headphone jack & front camera assembly from the iPad.
    • Peel the front camera off the foam adhesive securing it to the rear panel.

    • Remove the headphone jack & front camera assembly from the iPad.

  7. Carefully remove the strip of tape covering the front camera cable connector.
    • Carefully remove the strip of tape covering the front camera cable connector.

  8. Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.
    • Use the edge of a plastic opening tool to disconnect the front camera cable from the headphone jack cable.

结论

To reassemble your device, follow these instructions in reverse order.

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 4

总计 484