跳转到主内容

修复你的物品

维修的权力

商店

简介

Prereq only.

配件

没有特定配件。

  1. From here, the repair will be easier if you flip the computer around so the base is facing you.
    • From here, the repair will be easier if you flip the computer around so the base is facing you.

    • Remove the following four screws:

    • One 9.3 mm T10 Torx screw with a large head

    • Three 9.3 mm T10 Torx screws with a normal sized head

  2. Pull the optical drive thermal sensor connector straight up from its socket on the logic board. Pull parallel to the board. Pull the optical drive thermal sensor connector straight up from its socket on the logic board. Pull parallel to the board.
    • Pull the optical drive thermal sensor connector straight up from its socket on the logic board. Pull parallel to the board.

  3. Lift the inner edge of the optical drive and maneuver its connector past the GPU frame attached to the logic board. Carefully pull the optical drive off its mounting pins on the right side of the outer case to gain clearance for disconnecting the optical drive cable.
    • Lift the inner edge of the optical drive and maneuver its connector past the GPU frame attached to the logic board.

    • Carefully pull the optical drive off its mounting pins on the right side of the outer case to gain clearance for disconnecting the optical drive cable.

    • Allow the optical drive to hang down as you de-route the optical drive thermal sensor connector from behind the GPU heat sink.

  4. Disconnect the optical drive cable by pulling its connector away from the optical drive.
    • Disconnect the optical drive cable by pulling its connector away from the optical drive.

    • Remove the optical drive from the iMac.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 261