跳转到主内容

iMac Intel 20" EMC 2133 and 2210 Optical Drive Replacement

仅作为前提条件
本指南仅用作其他指南的先决条件。不能单独食用。

你所需要的

  1. iMac Intel 20" EMC 2133 and 2210 Optical Drive Replacement, Optical Drive: 步骤 1 中的图像 1,1
    • If necessary, remove the pieces of tape securing the hard drive/optical drive thermal sensor cables to your iMac.

  2. iMac Intel 20" EMC 2133 and 2210 Optical Drive Replacement: 步骤 2 中的图像 1,1
    • Disconnect the optical drive thermal sensor connector from the logic board by pulling its connector toward the top of your iMac.

    • When removing this connector, it is helpful to use your thumbnails to push the ears on either side of the connector toward the top of your iMac.

  3. iMac Intel 20" EMC 2133 and 2210 Optical Drive Replacement: 步骤 3 中的图像 1,1
    • Remove the two fine-thread 7 mm T10 Torx screws securing the optical drive to the rear case.

  4. iMac Intel 20" EMC 2133 and 2210 Optical Drive Replacement: 步骤 4 中的图像 1,1
    • Lift the free end of the optical drive slightly out of the rear case.

    • Remove the two 3.5 mm T6 Torx screws securing the optical drive connector to the optical drive.

  5. iMac Intel 20" EMC 2133 and 2210 Optical Drive Replacement: 步骤 5 中的图像 1,2 iMac Intel 20" EMC 2133 and 2210 Optical Drive Replacement: 步骤 5 中的图像 2,2
    • Insert the flat end of a spudger between the optical drive connector and the body of the optical drive.

    • Twist the spudger to separate the connector from the optical drive.

    • It may be necessary to work from alternating sides of the connector until it is disconnected.

  6. iMac Intel 20" EMC 2133 and 2210 Optical Drive Replacement: 步骤 6 中的图像 1,1
    • Lift the optical drive out of the rear case and pull it away from the side of the rear case to release the strip of EMI tape attached to its surface.

    • The optical drive thermal sensor is still attached to the underside of the optical drive.

结论

To reassemble your device, follow these instructions in reverse order.

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 0

总计 926