简介

Removing an old or broken PRAM battery.

Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.
  • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

添加评论

Loosen the four Phillips #0 screws.
  • Loosen the four Phillips #0 screws.

添加评论

Carefully remove the base access panel.
  • Carefully remove the base access panel.

添加评论

Remove the four 25mm T-15 screws. Remove the four 25mm T-15 screws.
  • Remove the four 25mm T-15 screws.

添加评论

Open the housing plate. Be gentle with the wires still connected to the logic board  so as not to ruin the cables.
  • Open the housing plate.

  • Be gentle with the wires still connected to the logic board so as not to ruin the cables.

  • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

添加评论

Gently remove the battery from its holder using the plastic opening tool. Insert new battery.
  • Gently remove the battery from its holder using the plastic opening tool.

  • Insert new battery.

  • Clean and re-apply thermal paste to the heat sink areas circled in Yellow. See Step 15 in iMac G4 17" Model M9168LLA Hard Drive Replacement for better photos and description.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Justin

于2011年10月05日注册

235 信誉积分

创作了3篇指南

团队

Cal Poly, Team 21-22, Maness Fall 2011 Cal Poly, Team 21-22, Maness Fall 2011 的会员

CPSU-MANESS-F11S21G22

4 名成员

创作了13篇指南

We are not allowed to use screwdrivers to pry open stuff. Unfortunately, that is exactly what we did in step 6 of Dissasembling the back up battery

David Hunter - 回复

Don't you need to replace the thermal paste?

adoug27 - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 14

过去的30天: 68

总计 5,469