简介

Removing the logic board assembly to replace it with a new one.

Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.
  • Unplug all the cables from the computer, including the power cable. Lay the computer face-down, supporting the neck and base with a soft cloth under the screen.

添加评论

Loosen the four Phillips #0 screws.
  • Loosen the four Phillips #0 screws.

添加评论

  • Carefully remove the base access panel.

添加评论

  • Remove the four 25mm T-15 screws.

添加评论

  • Open the housing plate.

  • Be gentle with the wires still connected to the logic board so as not to ruin the cables.

  • A fixed plug connector between the logic board and upper unit will cause some resistance. Pull gently but firmly.

添加评论

  • Gently remove the cables marked in red.

添加评论

  • Remove the three metal 10mm T-15 screws.

  • Remove the one nylon 10mm T-15 screw.

添加评论

  • Using thumbs and forefingers, firmly grasp the battery holder in one hand while grasping the metal bar in the other. Gently lift and pull the logic board to release it.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Justin

于2011年10月05日注册

235 信誉积分

创作了3篇指南

团队

Cal Poly, Team 21-22, Maness Fall 2011 Cal Poly, Team 21-22, Maness Fall 2011 的会员

CPSU-MANESS-F11S21G22

4 名成员

创作了13篇指南

We need to say what cables to remove in step 6 of Logic Board Assembly

Courtney - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 8

过去的30天: 42

总计 7,342