简介

Replacing this keyboard is easy and takes only a few minutes.

  1. Use a coin to rotate the battery locking screw 90 degrees clockwise.
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    添加评论

  2. Lift the battery out of the computer.
    • Lift the battery out of the computer.

    添加评论

    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

    添加评论

    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

    添加评论

    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

    添加评论

    • Remove the four silver Phillips screws that secure the RAM shield.

    添加评论

    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

    添加评论

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

附加文件

iRobot

于2009年09月24日注册

1 信誉积分

创作了623篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 6

总计 11,695