简介

One RAM slot will accept PC2700 chips up to 1 GB.

Use a coin to rotate the battery locking screw 90 degrees clockwise.
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  • Lift the battery out of the computer.

添加评论

Pull the keyboard release tabs (shown in yellow) toward you and lift up on the keyboard until it pops free.
  • Pull the keyboard release tabs (shown in yellow) toward you and lift up on the keyboard until it pops free.

  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw (shown in orange) 180 degrees in either direction and try again.

  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

添加评论

  • Loosen the four silver Phillips screws that secure the RAM shield.

  • These screws will not come out all the way. The screws are held captive to the RAM shield to prevent them from getting lost.

添加评论

  • Remove the RAM shield from the computer.

  • The four captive screws will come out with the RAM shield.

添加评论

  • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

  • When reassembling your iBook, make sure that you reconnect the keyboard cable before replacing the RAM shield.

添加评论

  • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

添加评论

  • Pull the chip directly out from its socket.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

24等其他人完成本指南。

附加文件

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 19

过去的30天: 96

总计 22,498