简介

One RAM slot will accept PC100 or PC133 chips up to 512 MB.

Use a coin to rotate the battery locking screw 90 degrees clockwise.
  • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  • Lift the battery out of the computer.

添加评论

Pull the keyboard release tabs (highlighted in red) toward you and lift up on the keyboard until it pops free.
  • Pull the keyboard release tabs (highlighted in red) toward you and lift up on the keyboard until it pops free.

  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

添加评论

  • If your computer does not have an AirPort card installed, skip to the RAM shield removal step.

  • Push the wire clasp toward the AirPort card and pull it up to free it from the RAM shield.

添加评论

  • Grasp the clear plastic tab on the AirPort card and pull toward the right.

添加评论

  • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

添加评论

  • Remove the two Phillips screws that secure the RAM shield.

添加评论

  • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

添加评论

  • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

添加评论

  • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

  • Pull the chip directly out from its connectors.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

10等其他人完成本指南。

附加文件

iRobot

于2009年09月24日注册

1 信誉积分

创作了621篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 8

过去的30天: 42

总计 28,486