跳转到主内容

iPad Air Wi-Fi版电池更换

注:你正在编辑的一份前提条件指南。你所做的任何更改将影响包括此步骤的5指南

英语
中文

正翻译步骤 1

步骤 1
iPad Air Wi-Fi Battery Replacement: 步骤 0 中的图像 1,3 iPad Air Wi-Fi Battery Replacement: 步骤 0 中的图像 2,3 iPad Air Wi-Fi Battery Replacement: 步骤 0 中的图像 3,3
  • The following steps instruct you to use heat to soften the glue securing the battery. A safer alternative is to inject a solvent, such as iFixit adhesive remover, between the battery and rear case to dissolve the adhesive.

  • Reheat the iOpener in the microwave for 30 seconds.

  • Remember to be careful not to overheat the iOpener during the repair procedure. Wait at least two minutes before reheating the iOpener, and never microwave it for more than 30 seconds.

  • Place the heated iOpener in the center of the back of the iPad. Let it sit there for 90 seconds to soften the battery adhesive.

  • Move the iOpener to the right (away from the rear-facing camera), and let the iOpener sit for another 90 seconds.

  • Finally, move the iOpener to the right-hand edge of the iPad for 90 seconds.

  • The iOpener may cool significantly between sittings—if it does, reheat for another 30 seconds between each position.

下面的步骤将指引你利用加热来软化保护着电池的胶水。你也可以用另一个更加安全的方法—在电池和后盖之间注射有机溶剂(比如iFixit adhesive remover )来溶解胶水。

在微波炉中重新加热iOpener 30秒钟。

在维修过程中请记住要小心不要让iOpener过热。 等待至少两分钟再重新加热iOpener,而不要微波30秒以上。

将加热过的iOpener放在iPad背面的中央。 让它放在那里90秒以软化电池胶。

将iOpener移动到右侧(远离后置摄像头),然后让iOpener再放置90秒。

最后,将iOpener移动到iPad的右侧边缘等待90秒。

iOpener可以在放置期间感到明显的冷却,如果是,则在每个位置之间重新加热30秒钟。

您的所有投稿皆享有基于开源创作共享许可协议(CC BY-NC-SA)著作权利