跳转到主内容

跳到步骤#2

Jose编辑

等待批准

之前
之后
不变

步骤行

-[* icon_note] The next few steps require a soldering iron.
-[* icon_note] The ends of the battery leads are fed through small holes in the logic board and held in place by a small amount of solder.
-[* black] Begin by heating the exposed end of the white battery lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.
-[* black] De-solder the remaining leads, following the procedure illustrated above.
-[* icon_caution] Due to the delicate nature of electronic components, it is imperative to limit the amount of heat transferred from the soldering iron to the logic board. An easy way to accomplish this is to pull on the battery lead with light, continuous tension, while the soldering iron heats up the connection. In order to avoid damage, lift the solder tip off the connection as soon as the solder melts and the lead slides out.
+[* icon_note] Los siguientes pasos requieren un soldador.
+[* black] Los cables de la bateria estan soldados a la placa en unos peque;os agujeros.
+[* black] Dessoldar los terminales siguiendo la ilustracion.
+[* icon_caution] Debido a la delicada naturaleza de los componentes electrónicos, es imprescindible limitar la cantidad de calor que se transfiere desde la punta del soldador a la placa. Una manera fácil de hacerlo es tirar de la batería con una ligera tensión, continua, mientras que el soldador calienta la conexión. Con el fin de evitar daños, levantar la punta de soldadura de la conexión tan pronto como se funde la soldadura y el cable se desliza hacia fuera.