跳转到主内容

跳到步骤#5

Andrew Bookholt编辑

等待批准

已删除
已添加
不变

步骤行

[* black] Remove the following 6 screws and 3 nuts from the heat sink:
[* black] One 2 mm Phillips extending from a finger on the left edge of the heatsink and adjacent the firewire port (not present on some models)
[*
red] ThreeFour 3 mm Phillips from around the fan (some models may only have 2 screws)and the heat sink bracket.
[* orange] One 3.511.5 mm (left) and one 4.5 mm (right) Phillips onfrom the left sideplastic fingers of the heat sink (not present on some models)hinge grill.
[* black] One 2 mm Phillips extending from a finger on the left edge of the heatsink and adjacent the firewire port (not present on some models)
[*
red] ThreeFour 3 mm Phillips from around the fan (some models may only have 2 screws)and the heat sink bracket.
[* orange] One 3.511.5 mm (left) and one 4.5 mm (right) Phillips onfrom the left sideplastic fingers of the heat sink (not present on some models)hinge grill.
[* yellow] One 4.5 mm Phillips at the top right corner of the heat sink.
[* green] OneTwo 6 mm Phillips aton the lower left corner and face of the heat sink.
[* violet] Two 4 mm screw nuts with attached springs from either side
of the heat sink.
[* green] OneTwo 6 mm Phillips aton the lower left corner and face of the heat sink.
[* violet] Two 4 mm screw nuts with attached springs from either side
of the heat sink.
[* blue] One 4 mm nut from the right side of the heat sink.
[* violet] Two 4 mm screw nuts with attached springs from either side of the heat sink.

图片1

没有之前的图片

已添加