跳转到主内容

跳到步骤#2

Tyler Starr编辑

编辑已通过 由 Tyler Starr

之前
之后
不变

步骤行

-[* black] Pull the slot on the top of the SD card reader from the 3DS to loosen the top edge of it
-[* icon_caution] There is a ribbon cable on the bottom of the SD card reader connected to the motherboard. Don't completely pull out the SD card reader at this point
-[* black] Use the flat end of a spudger to pry the SD card ribbon cable off the socket on the motherboard.
+[* black] Pull the SD card reader, from the edge with two holes, gently to free the tab at the top of the SD card reader.
+[* icon_caution] Don't completely pull the SD card out of the device yet there is a ribbon cable connected under the SD card reader.
+[* black] Reorient the device so that the power jack faces you and lift the SD card reader gently.
+[* black] Use a plastic opening tool to pry the SD card ribbon cable off the socket on the motherboard.
[* black] Lift the SD card reader out off of the lower casing.

图片1

没有之前的图片

已添加

图片2

没有之前的图片

已添加

图片3

没有之前的图片

已添加