跳转到主内容

跳到步骤#1

JR Alfano编辑

编辑已通过 由 JR Alfano

之前
之后
不变

步骤行

-[* black] Turn the device upside down to reveal the rubber section of the back plate. Using a metal spider carefully wedge the blunt tip into the space between the aluminum back plate and the rubber and separate the two pieces
- [* icon_note] This may take a few unites to to pry the rubber completely off and once your are able to get a good grip on the rubber it is easier to start peeling off with your hands
- [* icon_note] Don't worry about putting the rubber back on; the adhesive has plenty of strength to refix itself to aluminum when you are done
+[* black] Turn the device upside down to reveal the rubber section of the back plate. Using a metal spudger, carefully wedge the blunt tip into the space between the aluminum back plate and the rubber, separating the two pieces.
+ [* icon_note] This may take a few minutes to pry the rubber off completely. Once your are able to get a grip on the rubber it is easier to peel it off using your hands.
+ [* icon_note] Don't worry about re-applying adhesive to the rubber; the remaining adhesive has plenty of strength to affix itself to the aluminum.

图片2

旧版本

新版本

图片3

没有之前的图片

已添加