跳转到主内容

跳到步骤#1

JR Alfano编辑

编辑已通过 由 JR Alfano

之前
之后
不变

步骤行

[* black] Remove the external connector from its housing by lifting it up, then out.
[* black] Lift the internal power supply brick out of the device.
[* icon_note] You may have to wiggle the brick slightly when removing it, but it will lift straight up and out as nothing else is holding it down.
-[* red] Disconnect the SATA connector from the hard drive. This cable does not have a locking mechanism so it can just be pulled out.
-[* black] Disconnect the final power cable from the logic board.
- [* icon_note] Be careful when pushing in the tab on the logic board connector to release the cable lock.

图片2

旧版本

新版本

图片3

已删除