跳转到主内容

跳到步骤#1

Keaton Frahmann编辑

编辑已通过 由 Keaton Frahmann

之前
之后
不变

步骤行

[* black] Remove the external connector from its housing by lifting it up, then out.
-[* black] Next lift the internal power supply brick out of the device.
+[* black] Lift the internal power supply brick out of the device.
[* icon_note] You may have to wiggle the brick slightly when removing it, but it will lift straight up and out as nothing else is holding it down.
[* red] Disconnect the SATA connector from the hard drive. This cable does not have a locking mechanism so it can just be pulled out.
-[* yellow] Disconnect the final power cable from the logic board and be careful to push in the tab on the logic board connector to release the cable lock.
+[* orange] Disconnect the final power cable from the logic board.
+ [* icon_note] be careful to push in the tab on the logic board connector to release the cable lock.

图片3

旧版本

新版本