跳转到主内容

跳到步骤#1

Keaton Frahmann编辑

编辑已通过 由 Keaton Frahmann

之前
之后
不变

步骤行

-[* black] Remove the external connector from its housing by lifting it up, then out. Found next to the ethernet ports.
+[* black] Remove the external connector from its housing by lifting it up, then out.
[* black] Next lift the internal power supply brick out of the device.
[* icon_note] You may have to wiggle the brick slightly when removing it, but it will lift straight up and out as nothing else is holding it down.
[* red] Disconnect the SATA connector from the hard drive. This cable does not have a locking mechanism so it can just be pulled out.
+[* yellow] Disconnect the final power cable from the logic board and be careful to push in the tab on the logic board connector to release the cable lock.

图片2

旧版本

新版本

图片3

旧版本

新版本