跳到步骤＃1
由 Samantha Miller — 编辑
编辑已通过 由 Samantha Miller
- 之前
- 之后
- 不变
步骤行
| - | [* black] Turn the lens/flash assembly 90 degrees, until you see the two Phillips #00 screws. |
|---|---|
| - | [* icon_note] Refer to the image to locate the two screws. The screws are highlighted in red. |
| - | [* black] Remove the two screws with a Phillips #00 screwdriver. |
| - | [* black] Flip the flash so that you can access the remaining two screws. Remove these screws following the same method as before. |
| + | [* red] Turn the lens/flash assembly 90 degrees, until you see the two Phillips #00 screws, |
| + | [* red] Remove the two screws with a Phillips #00 screwdriver. |
| + | [* red] Flip the flash so that you can access the remaining two screws. Remove these screws following the same method as before. |
| [* icon_note] Refer to the second image to locate the second set of screws. The relevant screws are highlighted in red. | |
| - | [* icon_caution] Be careful while removing the screws. Do not strip or ruin the screws. You will need them to reassemble the camera. |