修复你的物品 社区 商店

跳到步骤＃24

由 Jeff Suovanen — 编辑

编辑已通过 由 Jeff Suovanen

之前
之后
不变

步骤行

[* icon_note] In the next steps, you will use an iOpener to apply heat to the rear case of the iPad to soften adhesive holding the logic board in place.
[* icon_note] As you reheat and place the iOpener in each of the indicated locations, leave it in place for at least a minute to soften the adhesive through the rear case.
-[* red] The adhesive is in the form of seven pieces of black foam tape—refer to this step as you work at heating and prying to keep track of where each piece is located.
+[* red] The adhesive is in the form of seven strips of black tape—refer to this step as you work at heating and prying to keep track of where each piece is located.