跳转到主内容

跳到步骤#1

Miroslav Djuric编辑

等待批准

之前
之后
不变

步骤行

-[* black] Remove the hard drive rubber side protectors from the drive sides.
[* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable.
-[* black] Use your forefinger to hold the ribbon cable in place; separate the drive from the ribbon cable.
-[* icon_caution] Make sure the hard drive rubber side bumpers are put back on the drive before reinstalling it. Use the hard drive rubber side bumper installation guide to accomplish this task.
+[* black] Use your forefinger to hold the ribbon cable in place; disconnect the drive from the ribbon cable.
+[* icon_note] Make sure the hard drive rubber side bumpers are attached to the drive being installed. Use the hard drive rubber side bumper installation guide to accomplish this task.
+[* icon_note] If necessary, the blue foam padding on the hard drive might also need to be transferred to the replacement drive.