跳转到主内容

跳到步骤#11

Jeff Suovanen编辑

编辑已通过 由 Jeff Suovanen

之前
之后
不变

步骤行

[* black] Use the edge of a plastic opening tool to gently pry up the display assembly around its perimeter.
-[* black] Remove the display assembly from the iPhone.
-[* icon_note] There is a small plastic ring around the front-facing camera that may come away with the screen. You may need to recover and reattach it to the camera, depending on whether your replacement screen includes a new ring.
-[* icon_caution] When reinstalling the display assembly, be sure the digitizer and display data cables are completely pulled through the slot cut into the outer case before pressing the display assembly down into the outer case. Failure to do so will cause the digitizer cable to not reach its socket on the logic board.
-[* icon_reminder] If you're replacing the display assembly, remember to take the metal mesh earpiece screen off the old display and put it on the new one. Most replacements do not include this mesh screen.
-[* icon_reminder] After reassembly, protect your new display from any scratches by installing a new [product|IF182-025|screen protector].
+[* black] De-route the digitizer and LCD cables through the steel inner frame.
+[* icon_reminder] When reinstalling the display, carefully straighten the digitizer and LCD data cables, and feed them through the slot cut in the outer case. [https://d3nevzfk7ii3be.cloudfront.net/igi/pOnFkdECiyCBgkjU|This photo|new_window=true] shows the display assembly being installed ***incorrectly***, with a fold in the digitizer cable.
+ [* black] When the front panel has been correctly installed, both the LCD and digitizer cables should be immediately next to one another and should be the same length, as shown in the second photo.
+ [* icon_caution] If the digitizer cable has been installed incorrectly, it will not reach its socket on the logic board. ***Do not*** attempt to pull it through by force, or it will tear. Remove the display assembly, straighten the cable, and feed it through to its full length, as shown.
+[* red] During reassembly, do not touch the metallic area at the base of the LCD data cable, as this can cause problems with the LCD. If you do touch it accidentally, clean it gently with an alcohol wipe before continuing.

图片2

旧版本

新版本

图片3

没有之前的图片

已添加