跳转到主内容

跳到步骤#18

Jeff Suovanen编辑

编辑已通过 由 Jeff Suovanen

已删除
已添加
不变

步骤行

[* black] On the left we see a row of dark coupling caps—probably in parallel. The tiny, light-colored dots within are ~~invading microorganisms~~ soldering voids, a remnant of the manufacturing process.
[* black] There is a relatively vast amount of brains in the charger. It probably understands the charging profile of the battery—so the watch doesn't have to. Cha-ching—space''Cha-ching''—space savings!
[* red] Up top, we spot a large BGA (ball grid array) which probably denotes the presence of a power management IC.

[* black] While the board is relatively complex, it only appears to be one layer, with no components on the bottom of the board.board (which makes sense because it needs to lay flat and charge).
[* redorange] With close inspection we spot a littler resistor network.
[* icon_note] Each filament in the network connects different points with a different resistorresistor.
[* black] One layerOne-layer PCB power management--not over probablymanagement—probably no more than 0.31 inch above the cables. (I am not sure on this, let's check with Bill)
[* black] On the left we see a row of dark coupling caps—probably in parallel. The tiny, light-colored dots within are ~~invading microorganisms~~ soldering voids, a remnant of the manufacturing process.
[* black] There is a relatively vast amount of brains in the charger. It probably understands the charging profile of the battery—so the watch doesn't have to. Cha-ching—space''Cha-ching''—space savings!
[* red] Up top, we spot a large BGA (ball grid array) which probably denotes the presence of a power management IC.

[* black] While the board is relatively complex, it only appears to be one layer, with no components on the bottom of the board.board (which makes sense because it needs to lay flat and charge).
[* redorange] With close inspection we spot a littler resistor network.
[* icon_note] Each filament in the network connects different points with a different resistorresistor.
[* black] One layerOne-layer PCB power management--not over probablymanagement—probably no more than 0.31 inch above the cables. (I am not sure on this, let's check with Bill)

图片2

旧版本

新版本

图片3

旧版本

新版本