跳转到主内容

跳到步骤#12

Brittany McCrigler编辑

编辑已通过 由 Brittany McCrigler

已删除
已添加
不变

步骤行

[* black] more s1 closeups
[* black] you can make out the part number on this guy, cause it was the one exposed chip
[* black] this isWe take a better piccloser look at the flash memory.
[* black] The flash chip looks flipchiped onto a the substrate with the balls are on the front side. We are taken back by the patterning
of the swirly drug trip section, maybe use this insteadballs because it is so irregular.
[* black] Looking at the patterning on the chip itself, focusing on the directions
of the earlier one.connections and vias, it looks like this flash is four layers—two signals, power, and ground.
[* black] Taking a closer look at the balls that connect the chip, we notice a few light-colored bubbles. This is called voiding.
[* black] Most contacts between boards are copper. But because copper oxidizes (rusts) very quickly, you have to wash it with an acid before you make the bond. This acid is called flux and is used to "wet" the tin solder. Voiding happens when the flux isn't completely cleaned off.
[* black] What's worse is it is bad for durability. Clean, even connections allow heat to dissipate and [http://creative.creativeelectron.netdna-cdn.com/wp-content/uploads/2014/10/EconomicsofLEDVoiding.compressed.pdf|voiding allow for heat build up, thus reducing the life of components.|new_window=true]
[* black] this isWe take a better piccloser look at the flash memory.
[* black] The flash chip looks flipchiped onto a the substrate with the balls are on the front side. We are taken back by the patterning
of the swirly drug trip section, maybe use this insteadballs because it is so irregular.
[* black] Looking at the patterning on the chip itself, focusing on the directions
of the earlier one.connections and vias, it looks like this flash is four layers—two signals, power, and ground.
[* black] Taking a closer look at the balls that connect the chip, we notice a few light-colored bubbles. This is called voiding.
[* black] Most contacts between boards are copper. But because copper oxidizes (rusts) very quickly, you have to wash it with an acid before you make the bond. This acid is called flux and is used to "wet" the tin solder. Voiding happens when the flux isn't completely cleaned off.
[* black] What's worse is it is bad for durability. Clean, even connections allow heat to dissipate and [http://creative.creativeelectron.netdna-cdn.com/wp-content/uploads/2014/10/EconomicsofLEDVoiding.compressed.pdf|voiding allow for heat build up, thus reducing the life of components.|new_window=true]