跳转到主内容

跳到步骤#5

Sam Goldheart编辑

编辑已通过 由 Sam Goldheart

之前
之后
不变

步骤行

-[* red] Use the flat end of a spudger or your fingernail to carefully flip up the retaining flap for each ribbon cable ZIF socket.
-[* blue] When disconnecting the ZIF socket lift from the center (blue) outwards to the edge of the board/towards the cables respectively.
+[* red] Use the flat end of a spudger or your fingernail to carefully flip up both retaining flaps one each of the ZIF sockets.
+ [* icon_note] When disconnecting the ZIF sockets flip them outwards to the edge of the board/towards the cables respectively.
[* icon_caution] Be careful not to damage the pin connector. Pull parallel to the device, not up.
[* icon_note] For more info on how to disconnect ZIF connectors, check out the [guide|25629|Recognizing & Disconnecting Cable Connectors guide|stepid=64969|new_window=true].

图片2

旧版本

新版本