跳到步骤＃2
由 Philip Le Riche — 编辑
编辑已通过 由 Philip Le Riche
- 之前
- 之后
- 不变
步骤行
| - | [title] Removal and refitting of the image sensor |
|---|---|
| - | [* black] The image sensor can be inspected or replaced without further disassembly of the lens. However, any dust or fingermarks may have a major impact on image quality and |
| + | [title] Removal and refitting of the image sensor and infrared filter |
| + | [* black] The image sensor and infrared filter can be inspected or replaced without further disassembly of the lens. However, any dust or fingermarks may have a major impact on image quality and correct realignment on reassembly is critical. It should therefore preferably be left alone. |
| [* black] With a small craft knife, scrape away the locking glue from the 3 screws securing the image sensor plate to the back of the lens. Take care to remove any loose fragments of glue which might fall into the lens. | |
| - | [* black] |
| + | [* black] Note the initial positions of the heads of the 3 screws and remove them, counting the number of turns required for each. Remaining glue will make these stiff - take care not to burr the heads. Gently ease the image sensor away, keeping the lens face-down on the bench. |
| [* black] Put the sensor aside, safe from dust contamination, such as in a self-sealing polythene bag. | |
| + | [* black] On reassembly it is important for accurate focussing that the 3 screws are each tightened by the same number of turns and to the same positions as before disassembly. apply screw locking compound to the heads to prevent movement. |