跳转到主内容

修复你的物品

维修的权力

商店

跳到步骤#6

Andrew Bookholt编辑

等待批准

之前
之后
不变

步骤行

[* icon_note] This step is performed with the motherboard out of the chassis.
[* black] Insert a machine screw through each of the four holes around the CPU heat sink, with their heads on the back side of the board.
[* black] While holding the head of the screw, place a nylon washer '''then''' a metal washer over the threads.
[* icon_caution] The order of the washers is important. '''Do not''' put the metal washer on first.
[* red] Using the large flathead screwdriver bit, thoroughly tighten the screws into the CPU heat sink. Don't be afraid of over-tightening the screws.
[* icon_caution] When attaching the CPU heat sink, be sure the fins are aligned with the air flow from the fans (as seen in the third picture). Having the flat side of the fins perpendicular to the air flow will cause your Xbox 360 to overheat.
[* red] Using the large flathead screwdriver bit, tighten the screws into the CPU heat sink. First lightly tighten the four screws in an X-shaped pattern as seen in the second picture, then follow the same X-shaped pattern to really torque the screws down.
[* icon_note] Don't be afraid of over-tightening the screws - the pressure between the heat sinks and processors caused by sufficiently torqued screws is needed to squeeze the processors back against the board.
[* icon_reminder] Repeat the same process to attach your GPU heat sink.

图片2

旧版本

新版本