跳转到主内容

跳到步骤#14

Philip Le Riche编辑

编辑已通过 由 Philip Le Riche

之前
之后
不变

步骤行

-[* black] On the bottom left hand side of the lens assembly there is a connector with a red and a black wire going to the speaker. Disconnect this, taking care not to strain the wires or the ribbon that the socket is mounted on.
+[* black] On the bottom left hand side of the lens assembly there is a connector with a red and a black wire going to the speaker. Disconnect this, taking great care not to strain the wires or especially the ribbon that the socket is mounted on.
[* black] At the rear top left hand side of the lens assembly is a ribbon cable connecting it to the flash module. Disconnect this.
[* black] (Note the transparent protective insulation covering the flash board just below this connector. Do not remove this as the board may still have a dangerous high voltage on it from the flash capacitor behind.)
[* black] Remove a screw from the top right hand side of the flash module, and separate the flash module from the lens assembly.
[* black] (On reassembly, hold the flash head closed while refitting it to the lens assembly.)