跳转到主内容

跳到步骤#19

Andrew Optimus Goldheart编辑

编辑已通过 由 Andrew Optimus Goldheart

之前
之后
不变

步骤行

[* icon_note] To remove the upper component board you will be pulling gently on its cable while lifting it up enough to clear the battery, but not high enough to scrape against the rear case. Go slowly and carefully.
[* black] Insert the tip of a spudger under the upper component control board to lift it slightly.
[* black] Pull the board up and out of the space between the battery and the rear case bezel.
-[* black] Remove the upper component control board.
+[* black] Remove the upper component board.
+[* icon_reminder] On reassembly, you'll want to reconnect the GPS antenna cable at this point. Use tweezers and work carefully.