跳转到主内容

跳到步骤#5

Jeremy Thompson编辑

编辑已通过 由 Jeremy Thompson

已删除
已添加
不变

步骤行

[* black] With a heat gun about 3-5 inches above the device, heat a section to enter with our prying tool. Slide the prying tool under the glass (Try to keep your prying tool from going too deep under the bezel of the glass. FAILURE TO DO SO MAY SCRATCH THE LCD.)
[* black] Go all the way around the screen (be sure to heat if you encounter any resistance, theresistance. (The adhesive is very easy to get through with a tool when hot) Once you have pried the glass up, pullset the home button aside, and release the clip holding the digitizer cable and pull the cable through the housing of the phone.
[* black] Be sure to remove all adhesive and put new adhesive in its place.
[* black] Route the new digitizer cable through the housing in the phone and insert into slot in motherboard. The lines on the cable will match the lines on the motherboard. Replace the home button (be sure to test it for that good ol' click!) and secure the glass.
[* black] Repeat the steps in reverse order for reassembly. Once you have secured the motherboard screw, front facing camera, and pushed all flex cables back in place, insert the battery, turn the device on and test the screen. If device tests successful, reassemble entirely. Congratulations, you did it!
[* black] Go all the way around the screen (be sure to heat if you encounter any resistance, theresistance. (The adhesive is very easy to get through with a tool when hot) Once you have pried the glass up, pullset the home button aside, and release the clip holding the digitizer cable and pull the cable through the housing of the phone.
[* black] Be sure to remove all adhesive and put new adhesive in its place.
[* black] Route the new digitizer cable through the housing in the phone and insert into slot in motherboard. The lines on the cable will match the lines on the motherboard. Replace the home button (be sure to test it for that good ol' click!) and secure the glass.
[* black] Repeat the steps in reverse order for reassembly. Once you have secured the motherboard screw, front facing camera, and pushed all flex cables back in place, insert the battery, turn the device on and test the screen. If device tests successful, reassemble entirely. Congratulations, you did it!

图片1

旧版本

新版本

图片2

没有之前的图片

已添加

图片3

没有之前的图片

已添加