跳转到主内容

跳到步骤#5

Jeremy Thompson编辑

编辑已通过 由 Jeremy Thompson

已删除
已添加
不变

步骤行

[* black] With a heat gun about 3-5 inches above the device, heat a section to enter with our prying tool. Slide the prying tool under the glass (Try to keep your prying tool from going too deep under the screenbezel of the glass. FAILURE TO DO SO MAY SCRATCH THE LCD.)
[* black] Go all the way around the screen (be sure to heat if you encounter any resistance, the adhesive is very easy to get through with a tool when hot) Once you have pried the glass up, pull the digitizer cable through the housing of the phone.
[* black] With a heat gun about 3-5 inches above the device, heat a section to enter with our prying tool. Slide the prying tool under the glass (Try to keep your prying tool from going too deep under the screenbezel of the glass. FAILURE TO DO SO MAY SCRATCH THE LCD.)
[* black] Go all the way around the screen (be sure to heat if you encounter any resistance, the adhesive is very easy to get through with a tool when hot) Once you have pried the glass up, pull the digitizer cable through the housing of the phone.

图片1

没有之前的图片

已添加