跳转到主内容

跳到步骤#13

Stefan Van pellicom编辑

编辑已通过 由 Stefan Van pellicom

之前
之后
不变

步骤行

+[* black] These are the capacitors to replace. PLAN in ***which order*** you will do the resoldering in the last step. Make sure your tip doesn't touch anywhere except on the spot you want to apply the heat ...
+[* black] To remove : use a pair of fine tipped cutting pliers, and cut the capacitors as low as jou can. The bottom of the can is encased in een rubberlike material, and is easily removed using tweezers.
+[* black] Then de-solder the capacitor's legs still attached to the circuit board, and provide a new clean patch of solder to the soldering islands.
+[* black] Now install the new capacitors. Mind you, this is NOT to be done with your average soldering iron. You will need a 0,8mm tip or SMD tweezers. And you'd better have darn good eyesight ... :)

图片1

没有之前的图片

已添加