跳转到主内容

跳到步骤#5

Stefan Van pellicom编辑

编辑已通过 由 Stefan Van pellicom

之前
之后
不变

步骤行

[* black] We will now disconnect the 2 flatcables that connect the camera module to the camera base.
[* red] The ferrite core is attached to the left cable connector with some 2-sided sticky tape. Gently pry it loose so it can slide upward along the cables.
-[* green] The 2 brown/white cable connectors can now be reached. The brown part has to slide UP. Pry it loose with a very fine instrument : bit on the left, bit on the right, en and repeat until loose. It should remain seated in the connector body. If it's no longer clamped, you're far enough ! FRAGILE !
+[* green] The 2 brown/white cable connectors can now be reached. The brown part has to slide UP. Pry it loose with a very fine instrument : bit on the left, bit on the right, and repeat until loose. It should remain seated in the connector body. If it's no longer clamped, you're far enough ! FRAGILE !
[* black] Gently bend the ribbons to the side, so the camera module is exposed.