跳转到主内容

跳到步骤#3

iRobot编辑

等待批准

之前
之后
不变

步骤行

+[* icon_note] Due to variations between iBook G4 models, your heatsink may have either 5 or 6 screws. We've noted all possible positions for screws in the step below. If there's no screw to remove, then skip to the next screw. Be sure that you remove all necessary screws before attempting to remove the heat sink.
+[* black] Remove the following 6 screws and 3 nuts from the heat sink:
+ [* black] One 2 mm Phillips extending from a finger on the left edge of the heatsink and adjacent the firewire port (not present on some models)
+ [* red] Three 3 mm Phillips from around the fan (some models may only have 2 screws).
+ [* orange] One 3.5 mm Phillips on the left side of the heat sink (not present on some models).
+ [* yellow] One 4.5 mm Phillips at the top right corner of the heat sink.
+ [* green] One 6 mm Phillips at the lower left corner of the heat sink.
+ [* blue] One 4 mm nut from the right side of the heat sink.
+ [* violet] Two 4 mm screw nuts with attached springs from either side of the heat sink.

图片1

没有之前的图片

已添加