跳转到主内容

跳到步骤#10

Dave Fixedit编辑

等待批准

已删除
已添加
不变

步骤行

[* black] Slide the housing back over the magsafe connector. It goes on either way round (there is a hole for the led on both sides.
[* black] Squeeze in place with the pliers. If it doesn't fit over the circuit board fairly easily, check that you don't need to file down the solder joints some more.
[* black] Slide the first of the pieces of heatsink up against the plastic housing.
[* black] Keeping it tight, shrink it in place. This is important to help avoid a future failure.
[* black] Repeat with the outermost piece of heatshrink.
[* black] Try powering it up! Remember that it will take a few seconds before the LED illuminates.
[* black] Orange light - success!

图片1

没有之前的图片

已添加